Contributor
LCC install help
Just installed the LCC this am and all seemed well except after the setup and I go to my local station I still see the message due to Nexstar dispute. I go into sat/antenna menu and into edit channels. I see the four digital channel from my local station plus one that says null. On that screen I can not move around at all to remove a channel. All I get is the beep you here if you push a wrong button. So far I have tried uplugging the LCC power and usb connections, running setup several times and just reset my receiver (HR44-700). If I hook antenna up to my smart TV I can see the channels fine, but want to be able to DVR. Any ideas?
Accepted Solution
Official Solution
nabukl
ACE - Professor
•
2.3K Messages
5 years ago
The antenna goes on the tv not the receiver that's how the dtv guide picks them (via the tv).
0
NikkielAd
Contributor
5 years ago
That is not what the directions say! It says to plug USB into the receiver.
0
0
kd3yt1
Contributor
5 years ago
Actually I had followed the directions. Antenna to LCC, USB to receiver. I just marked this as solved did not mean I followed the wrong post. Anyways, I am behind mountain and unless I put the antenna up very high signal is marginal. Ended up subscribing to CBS all access and can get my local station. I just wish ATT and Nexstar would settled this dispute.
0
0
nabukl
ACE - Professor
•
2.3K Messages
5 years ago
@NikkielAd , my reply was incorrect info I had no idea that it connected to the dvr itself and not the tv like you would normally connect an antenna.
0
0
tmmuch
Teacher
•
24 Messages
11 months ago
I'm reviving this thread, since I had trouble with some of my OTA channels after installing my LCC.
The LCC instructions tell you to RE-SCAN your local stations.
Fine.
But I found that I had to RE-SET first (especially if you had been using an AM21 prior), THEN re-scan.
This fixed an issue for me of not being able to receive some sub-channels of stations that I previously had gotten OK.
0
0