1 Message
U-verse signal has been lost. Only on active channel for a few seconds.
Modem: BGW320-505, installed two months ago. Set-top boxes: Cisco ISB7005, connected by ethernet cable. Since our modem was replaced two months ago, our U-verse TV channels freeze every few minutes on both our TV sets. Some Details: After frozen for a minute or so, an error message appears on the screen: “U-verse signal has been lost”. If we wait several minutes, the TV feed resumes. If during a freeze I switch channels, other channels work immediately. If I switch channels and back to the first it is working, even if I switch back within a couple of seconds. The freezing seems more frequent on some channels and times of day. Recently, in the evening, channel 1030 is unwatchable; it freezes for a few seconds several times a minute.
Accepted Solution
Official Solution
DIRECTVhelp
Community Support
•
254.4K Messages
2 years ago
Let's get your U-Verse TV service stable, @PeavineObserver!
For your channels freezing, we always recommend performing a reboot of your gateway first. This will refresh your internet connection and can resolve a host of concerns, such as your channels freezing.
You can reset your gateway with these steps:
Along with that, we have a very helpful troubleshoot and resolve tool online for your U-Verse TV service. Just sign in and you can start troubleshooting your receivers. Lastly, try using a different Ethernjet cable. These cables can become damaged to everyday use so that could possible be the cause.
Let us know how these troubleshooting steps work for you!
CalebP, AT&T Community Specialist
0
0